Hi there,
Another set of questions that someone will hopefully answer.
I’m planning a domestic ground floor renovation incorporating wet UFH.
The build up consists of:
Damp proof membrane over existing concrete floor
20mm Low profile boards with 16mm pipes - either EPS or XPS 300 kPa - no foil to react with screed - boards taped together and holes filled with expanding foam.
20mm insulating edging around external walls and Perimeter Edge Strip throughout
40MM Cemfloor therm floating screed laid directly ontop - 35mm min above pipes which are recessed into the boards
Then a final finish of potential ARDEX K80 with matte sealer, an exposed concrete floor look.
We only have about 70mm to work with so this was the reasoning.
Will this work? Will the pipes float in the screed? Have I made a huge mistake? Theres obvsiouly a lot more details to it which I can offer if needed.
Boards in mind:
www.thefloorheatingwarehouse.co.uk
theufhgroup.co.uk
Another set of questions that someone will hopefully answer.
I’m planning a domestic ground floor renovation incorporating wet UFH.
The build up consists of:
Damp proof membrane over existing concrete floor
20mm Low profile boards with 16mm pipes - either EPS or XPS 300 kPa - no foil to react with screed - boards taped together and holes filled with expanding foam.
20mm insulating edging around external walls and Perimeter Edge Strip throughout
40MM Cemfloor therm floating screed laid directly ontop - 35mm min above pipes which are recessed into the boards
Then a final finish of potential ARDEX K80 with matte sealer, an exposed concrete floor look.
We only have about 70mm to work with so this was the reasoning.
Will this work? Will the pipes float in the screed? Have I made a huge mistake? Theres obvsiouly a lot more details to it which I can offer if needed.
Boards in mind:
ThermRite™ ProTile20 – PREMIUM OUTPUT 20mm Cementitious Insulation Panel
ThermRite™ ProTile20 - PREMIUM OUTPUT 20mm Cementitious Insulation Panel - Accepts Tile Floors Directly | The Floor Heating Warehouse
The Ideal Low Profile Solution for installation of a water system onto existing floors and install tile floors directly on top High Output 150mm Pipe Centres with Thick Cementitious Layer Features: High Strength: 300kPa compressive strength High Output: Thick cementitious covering Low Profile...
www.thefloorheatingwarehouse.co.uk
20mm Tekwarm EPS (Expanded Polystyrene) Thermo 300KPA
20mm Tekwarm EPS (Expanded Polystyrene) Thermo 300KPA Plus+ | 1200 x 6
TEKWARM Thermo (EPS Expanded Polystyrene) 300KPA Plus+ is a higher performance lightweight EPS insulation routed on one side with optional aluminium foil applied to routed side of board. TekWarm Thermo (EPS Expanded Polystyrene) 300KPA Plus+ is a high-performance Expanded Polystyrene (EPS)...
theufhgroup.co.uk
