Hi after experiencing the same issue as a lot of people and reading a lot of questions around ovens tripping the RCD. I want to move the oven off the RCD to see if I can start to use my oven normally again instead of having to keep the temperature under 150degrees (to prevent the RCD from tripping)
It's the first to the right of the orange looking trip switch.
I presume once all the power is cut off I would have to unscrew the oven circuit and move it over to the lefthand non protected side. However as I was searching what to do I saw a post which says to move the neutral over and wasn't sure what that entailed.
Is this something that is obvious once I attempt to move the circuit over as didn't want to poke around too much until I posted here
I've attached a picture of my box if you can help me out
Cheers Everyone!
It's the first to the right of the orange looking trip switch.
I presume once all the power is cut off I would have to unscrew the oven circuit and move it over to the lefthand non protected side. However as I was searching what to do I saw a post which says to move the neutral over and wasn't sure what that entailed.
Is this something that is obvious once I attempt to move the circuit over as didn't want to poke around too much until I posted here
I've attached a picture of my box if you can help me out
Cheers Everyone!