Hello
I'm going to be putting up a stud wall with a big enough for 2 pairs of 600mm french door from wickes.
the width of the whole wall will be 3.6m and the opening will be 2.4m
this leaves just 0.6m of wall on each side.
after doing a bit of searching, i think i'll be going for 2x4 timber.
does this sound right? I'm not sure if it should be PSE or not.
I'll be using 12.5mm plasterboard, so i guess i'mm looking at 5 inch wide doorframe.
I'd be gratefull if anyone can point out any problems, or better suggestions...
many thanks
PS - no skimming, just tape and filler on the joints if that makes a difference.
I'm going to be putting up a stud wall with a big enough for 2 pairs of 600mm french door from wickes.
the width of the whole wall will be 3.6m and the opening will be 2.4m
this leaves just 0.6m of wall on each side.
after doing a bit of searching, i think i'll be going for 2x4 timber.
does this sound right? I'm not sure if it should be PSE or not.
I'll be using 12.5mm plasterboard, so i guess i'mm looking at 5 inch wide doorframe.
I'd be gratefull if anyone can point out any problems, or better suggestions...
many thanks
PS - no skimming, just tape and filler on the joints if that makes a difference.