Hi.
I have a damaged (frost) angled tap connector that feeds the cold water storage in a loft. Its around 60 years old. Galvanised tank, 15 mm pipework, but all works well so would just like to replace the connector and a short piece of pipe and add a service valve.
Trouble is I don't have the correct size. Its smaller than 1/2 inch.
I'd like to simply collect a replacement and fit it so what is the male end of the protruding fitting likely to be please?
I have a damaged (frost) angled tap connector that feeds the cold water storage in a loft. Its around 60 years old. Galvanised tank, 15 mm pipework, but all works well so would just like to replace the connector and a short piece of pipe and add a service valve.
Trouble is I don't have the correct size. Its smaller than 1/2 inch.
I'd like to simply collect a replacement and fit it so what is the male end of the protruding fitting likely to be please?