Visiting some relatives in Wales and noted they had a new bathroom fitted in their 1966 3 bed bungalow. The shower / tiling work / ceiling looks hmm, fair, but I also took a look at the wiring in the attic and found this:
It looks like a bit of dodgy diy to me.
There was just one pendant and now it's four spotlights. The cost was "£25 per light", so £100 all in and that sounds a bit cheap.
What about IP rating and zone?
The old bath was taken out and a new walk in show put in. The size of the bathroom is about 6ft x 6ft so this is all zone 1 and zone2? The consumer unit is over 50 years old and does not have RCD. I don't think they changed anything on the CU so this circuit should have an RCD right?
It looks like a bit of dodgy diy to me.
There was just one pendant and now it's four spotlights. The cost was "£25 per light", so £100 all in and that sounds a bit cheap.
What about IP rating and zone?
The old bath was taken out and a new walk in show put in. The size of the bathroom is about 6ft x 6ft so this is all zone 1 and zone2? The consumer unit is over 50 years old and does not have RCD. I don't think they changed anything on the CU so this circuit should have an RCD right?