I would fix tile backer boards to the wall and tile onto that, here are some instructions for fixing to a brick wall ;
8. 1. Installation on brick walls
8.1.1 Preparing the substrate
Ensure wall is sound, clean and ready to receive HardieBacker®
250 cement board. At minimum, the rear of HardieBacker® 250
cement board and the masonry wall must be wiped down to
remove all dust.
8.1.2. Fixing sheets with tile adhesive, step 1
Bond HardieBacker® 250 cement board to the masonry walling
using tile adhesive. Apply tile adhesive to masonry walls using a
6mm notched trowel. The tile adhesive must fully support HardieBacker
® 250 cement board and the HardieBacker® 250 cement
board is firmly pressed into the tile adhesive.
8.1.3 Fixing sheets with masonry anchors, step 2
Use 9 pcs (3 rows of 3) ø 6mm x 50 mm masonry anchors with
self embedding head. The masonry anchors are immediately
fixed through the board into the masonry walls holding the
sheeting in place. Do not overdrive head of anchor, it must be
flush with face of HardieBacker® 250 cement board.
Note: Do not dot and dab tile adhesive.
It would be easier just repairing the damage to the walls, rather than making a big job out of it. That is unless the basecoat plaster is also shot at?
I like the idea of the hardiebacker boards but don't really have the extra depth to play with. How about a sand & cement skim - I should be able to do it myself and won't have to wait long for it to dry?
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local