I am looking to convert a radial circuit (2.5mil) to a ring main. I understand about adding from the last socket and back to the CU. However on checking the wiring layout, it goes as follows... from the CU to 30amp junction boxes, wire continues to next Junction box and so on to last socket. Each socket is fed from each junction box a single wire (spur) goes to the socket...(instead of 2.5 wire in and out of the socket as per diagram on site).
Question: Is it still accepable to convert this circuit to a ring main, either continuing using junction boxes or 2.5mm straight back to CU?
Question: Is it still accepable to convert this circuit to a ring main, either continuing using junction boxes or 2.5mm straight back to CU?