Hello,
I just moved from a ProSys to a ProSys plus system by mylself.
All looks to be right but I cannot figure out how to program the 'stay' button'.
At the moment if I press the button all the zones are armed. Of course I would like tot disable all the internal motion detector devices.
In the CS software I was not able to find any special config...
Thank You
Regards
M.
I just moved from a ProSys to a ProSys plus system by mylself.
All looks to be right but I cannot figure out how to program the 'stay' button'.
At the moment if I press the button all the zones are armed. Of course I would like tot disable all the internal motion detector devices.
In the CS software I was not able to find any special config...
Thank You
Regards
M.