I am redoing my bathroom that currently has the shower electrical feed routing up through the floor boards, loose along the underside of the bath and into the loft through the waste pipe boxing. As this also houses the hot water feed from the boiler in the loft I don't think its the best solution!
The stud wall at one end of the bathroom is of the type that has cardboard lattice work internally. I have managed to punch a channel all the way from top to bottom using some drain rods. The channel is within the 150mm Safe Zone of the corner wall.
My question is, do I need to install conduit to run the cable through or can I just feed it through the hole I have created?
The stud wall at one end of the bathroom is of the type that has cardboard lattice work internally. I have managed to punch a channel all the way from top to bottom using some drain rods. The channel is within the 150mm Safe Zone of the corner wall.
My question is, do I need to install conduit to run the cable through or can I just feed it through the hole I have created?