Scantronic (8136) - set/unset via a zone

Bit of progress, if I set the zone to KF rather than KM. Then completing the circuit on the zone now puts the alarm (Level A) into a kind of set mode, but the sounder maintains a steady tone, and it never completes the set.
 
Sponsored Links
Typing my alarm code in during this process performs an unset..confusing!
 
These are from the 808 /816 manual ( non idis version ) may help you …..only problem I can see with this type of key switch setting is when it’s not turned off by this method it will be out of sync….
 

Attachments

  • IMG_5648.png
    IMG_5648.png
    235.1 KB · Views: 39
  • IMG_5647.png
    IMG_5647.png
    289.1 KB · Views: 30
D

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
You must log in or register to reply here.
Sponsored Links

Similar threads

A
scantronic 9752 connect to smarthome help needed
Replies
3
Views
1K
secureiam
secureiam
B
Recommendation for wired alarm system for competent amateur in new build
Replies
3
Views
812
daern
D
C
Honeywell galaxy flex final zone issue
Replies
3
Views
2K
Crs19
C
G
How can I set my Scantronic to silent alarm?
Replies
5
Views
2K
gunnersmate
G
Meza
Unable to disarm DSC PC1832 via delay zone, system goes into alarm
Replies
7
Views
3K
Doggit
D
Back
Top