- Joined
- 27 Dec 2018
- Messages
- 77
- Reaction score
- 4
- Country
I'm probably missing something obvious here but I can't get soak test to work.
I've set the attributes to 'On Test' on every zone in wintex (exlcuding front door contact), I've then gone into engineer utils and enable soak test one Area A. But every zone is causing a full alarm. I've doubled checked on the keypad too and the T attribute is on there.
What's going on
I've set the attributes to 'On Test' on every zone in wintex (exlcuding front door contact), I've then gone into engineer utils and enable soak test one Area A. But every zone is causing a full alarm. I've doubled checked on the keypad too and the T attribute is on there.
What's going on