Teying to cut shelf for a space in the bathroom
- Thread starter iffy100
- Start date
Tape measure....
Go on mate. You're a star.
Yes I could do that, but just want to do it absolutely properly
I would measure all sides. Transfer onto a cardboard template and then cut that cardboard to those measurements. Tweaking it as you go.
Once it fits perfectly, use that template to mark and cut the wooden shelf..
Once it fits perfectly, use that template to mark and cut the wooden shelf..
Measure the back dimensions/length of the alcove.
Transfer those dimensions to your shelf.
Take two bits of 2 by 1 timber. Put a screw in the end. Offer it up to the first corner. Tighten up the screw. Transfer the first angle to the shelf and draw a pencil line. Do the same at the other end (using the same technique).
If the back wall has a bow in it, do the above but leave each end slightly overlength. Offer the shelf up, tilt it and use a pencil to follow the profile of the back wall. Then use a belt sander or jigsaw depending on how much material you need to remove.
Transfer those dimensions to your shelf.
Take two bits of 2 by 1 timber. Put a screw in the end. Offer it up to the first corner. Tighten up the screw. Transfer the first angle to the shelf and draw a pencil line. Do the same at the other end (using the same technique).
If the back wall has a bow in it, do the above but leave each end slightly overlength. Offer the shelf up, tilt it and use a pencil to follow the profile of the back wall. Then use a belt sander or jigsaw depending on how much material you need to remove.
No good Kools, he wants to do it properly.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
