Well that doesn't happen for me - not any more.
Veritas Burglar Alarm
- Thread starter favemuppet
- Start date
Well that doesn't happen for me - not any more.
Sponsored Links
I need to do this walk test. Why is the difference between latching and non-latching?
Walk Test done. Appear to be no problems - all zones beeped as they should. No sequences of 9 nor 10 - no tamper light on.
Sponsored Links
A
Alarm
So what happens now when you try and set?
Same as before - tamper light comes on, and zones 1 and 2 flash during the omit process.
A
Alarm
Forget omitting do a full set.
The flashing zones tell us what will be armed in the part set.
The flashing zones tell us what will be armed in the part set.
Zones 1, 4, 5, 6, 7 and 8 flash steadily (6, 7 and 8 aren't used). Zone 2 flashes quickly. Zone 3 does nothing. Tamper light on.
A
Alarm
Link out zone 3
Link out the global tamper
Link between C and D on the sounder at the panel.
Then we should have a working panel.
Try that.
Link out the global tamper
Link between C and D on the sounder at the panel.
Then we should have a working panel.
Try that.
Still not done anything about this but interestingly, today the keypad started sounding an alarm. Outside box wasn't, main unit wasnt, just the keypad. Wouldnt respond to any key presses, had to wait a few minutes until it went off by itself. Zone 1 is lit and cannot be cleared. Have sinced switched it off at the fuse box.
Is this totally dead?
Is this totally dead?
no, expect the outside bell to start ringing around 3 am tomorrow morning
Am I right to sense sarcasm there or are you being deadly serious?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
