Search results

  1. G

    door savable?

    hi , I bought a cat n car , car was hit on wheel , but part of the damage is hit the door as seen in pictures. the door clips wing as wing has been pushed forward. before I spend money on a new door , can this one be repaired .
  2. G

    outside light

    the old outside light that was a circle has died , its going to be replaced with a pir floodlight , the light has a Small cable entrance that has a shroud and gromit. the old light the t&e went into its rear casing , the new one is about 5 inches from wall. to run this cable to the new fixing...
  3. G

    ceiling damage

    I had a leak from loft watertank . it was dripping from ceiling onto floor In hall and possibly running down inside a wall (covin Is stained, but wall feels dry). the bathroom celing was bulging, so I screwdrivered it to release the water, and threw out all wet stuff in loft I need to...
  4. G

    expected price to pay

    hey , I'm looking for what a good price would be to renew my central heating system . its a unvented system with tank in loft and cylinder next to boiler ., wantnit changed for combi I want new piping change from 15 mm for flow and return , and 8mm to rads. to 22x15 boiler will stay where...
  5. G

    boiler fault

    hi guys , I've a glowworm fuelsaver f35 , it was full of water and I switched of electric and valves and found this . (pics). can this be saved?, there was loads of rusty water or do yous think the heater exchange will be burst. ..it was during to cold snap , and boiler hasn't been on.
  6. G

    flood damage

    hi , went away on holiday for 2 weeks , came back and bathroom floor was wet and my small hall carpet is wet . the celing had a bulge in until (not huge) I put a few holes (went through artex no bother) and a filled a bucket . I switched all water off and cleaned up the bathroom. around...
  7. G

    what should i pay

    looking to replace my boiler. its a glowworm fuel saver 3 , and will be changing 4 rads, (1 double and 3 singles) and adding a column 1 in kitchen . will the ce pipes that are 8mm need replacing? the water tank is in loft and services the bathroom aswell as cylinder, do the fitters...
  8. G

    frozen boiler

    I've not been staying at house and the heating was on frost protection. my system is a conventional one. my water header in loft has 1 inch thick ice inside it . my hot water (pipes run under house) and water from header tank has frozen (runs down next.to outside wall behind tile, I've put...
  9. G

    Central heating pipes

    Hi , Im thinking of.replacing all my old radiators that are nearly 40 year old . The piping to the rad is 8mm microbore connected to 22mm pipe that is laying g on ground, half of it is insulated. I want to change this to 15 mm to rads and a new length of 22mm. Under my floors I can crawl...
  10. G

    What block paving is this

    Hi , im resetting my.monoblock driveway as they moved, but was going to carry the paving further , but want same blocks . Can some one identify these , they are from 1984
  11. G

    New boiler

    Hey guys . I have a glowworm fuel saver 3, its a g rated boiler , it feeds 4 radiators and a towel rail. , everything uses 8mm apart from towel rail , thats 15mm. The boiler will come on for 1 min , then go off for a min , and repeat this process and it takes 1 hr to go up 1 degree. The...
  12. G

    Resin garden

    Im thinking of doing a resin patio and driveway. At the rear its full of weeds and the monoblock on drive way has weeds growing through them and blocks have had there day . So was thinking of doing resin . Is it correct to dig all the grass out down to a depth of about 4 inches. Mix up...
  13. G

    Central heating pipes and rads

    Im wanting to upgrade my central heating before I get a new boiler fitted . What I have just now is 2 rows of 15mm copper pipe running under floor with no installation. (Flow and return) From each piece it feeds 4 radiators from 1985 with microbore pipe , think its 8mm. The boiler is having...
  14. G

    Ford fiesta mk7 heater and clicking

    Hi . I've a fiesta mk7 tdci titanium 2009 with automatic climate control. From behind the dash is 2 clicking noises . One just behind the controls and one sounds further back . It started the heating wouldn't come through the blowers at any force. Just footwell. And was working on all...
  15. G

    candy grand o vita heatpump

    hi guys got the.candy heatpump dryer.9kg. its just over year old not used much as i usually stick clothes on clothes horse when i dry a load (about 3kg). the water tank does not collect water. and it steams windows up. and.any program. including 40 min rapid . they are still damp. filters...
  16. G

    Bosh oven front glass

    Hi I'm looking for.a front replacement glass for the oven door. The model is hba63b2.2b I've looked online and can't see one that's like mine. It has two aluminium strips up the sides where the glass is . And it uses white location rubber grommets to a fix to the frame. Glass is black in...
  17. G

    Gw fulesaver f35

    I hAve a glowworm fuelsaver f35, It's been working good using my hive thermostat. Lastnight I put hotwater on ,but no hotwater, I checked boiler and the pump runs,fan runs but no pilot light . So I took bottom off and the red ignition button just pushes up so that tells me that it wasn't a...
  18. G

    fitted oven (s) breaker box

    Hi guy's. I got a bosh series 6 single self cleaning oven (16amps) And a bosh series 6 combination oven (16amps) Both have fitted leads like you would see on a kettle. They are connected to a dual appliance connection point. That goes to the isolation switch (40amp fitted with 6mm to the...
  19. G

    wrong cut to b filled

    Guys. I was cutting a decorative tall fridge housing gloss white claddon panel. Had it clamped with pump clamps and used my circular saw and the clamp failed. It cut a 6 inch line accross panel. Its at top of panel against wall. What can I use to fill the cut and match it to gloss white...
  20. G

    worktop joining bar

    Hi guys. Got two bits of worktop that have a square edge profile. The corner join bar I got has a 6mm round radius on one side. But doesnt go over the square edge or worktop. Ive been trying to find one that I can use to join two square pieces together. I got one from sf but didnt work...
Back
Top