Hi,
I'm trying to install a lightsys 2 alarm, I have zero experience of this but I've got to sort out 5 flats so I have 5 of these to do and I'd rather learn how to do it myself than pay for someone else to do it.
I think there is an assumption in the instructions of prior knowledge, like how to wire a PIR. Which is probably fair enough but I need help!
Sorry if these are a bit basic:
1 - Is there a wiring diagram for the PIR? I cannot find one that is simple enough for me, and shows exactly where the 6 terminals should be connected (for a given zone). Is the 7th terminal (LED) connected to anything?
2 - I cannot wire up the bell without the bell temper being triggered. There seemed to be instructions for connecting the bell in the wiring diagram which I'm pretty sure I followed (in the attached picture)
3 - Should each of the unused zones have a resistor between the Z terminal and the COM terminal? That's what I did to stop the zone tampers triggering. Is that right or is that mad?
4- there is some configuration software that runs on Windows but the Risco website won't let me download it. Or pay for it. Does it allow me to perform all configuration on a laptop rather than messing with the panel?
If the answer is to read some guide, then please point me towards it.
Thanks for your help,
Euan
I'm trying to install a lightsys 2 alarm, I have zero experience of this but I've got to sort out 5 flats so I have 5 of these to do and I'd rather learn how to do it myself than pay for someone else to do it.
I think there is an assumption in the instructions of prior knowledge, like how to wire a PIR. Which is probably fair enough but I need help!
Sorry if these are a bit basic:
1 - Is there a wiring diagram for the PIR? I cannot find one that is simple enough for me, and shows exactly where the 6 terminals should be connected (for a given zone). Is the 7th terminal (LED) connected to anything?
2 - I cannot wire up the bell without the bell temper being triggered. There seemed to be instructions for connecting the bell in the wiring diagram which I'm pretty sure I followed (in the attached picture)
3 - Should each of the unused zones have a resistor between the Z terminal and the COM terminal? That's what I did to stop the zone tampers triggering. Is that right or is that mad?
4- there is some configuration software that runs on Windows but the Risco website won't let me download it. Or pay for it. Does it allow me to perform all configuration on a laptop rather than messing with the panel?
If the answer is to read some guide, then please point me towards it.
Thanks for your help,
Euan