- Joined
- 22 Sep 2015
- Messages
- 50
- Reaction score
- 0
- Country

Hi all. I want to install tado V3.
I think I have an s-plan system which comprises:
Cheers
I think I have an s-plan system which comprises:
- Worcester Bosch Greenstar 30cdi (gas)
- Hot water tank with immersion heater
- 2 motorised zone valves (2 port each). One for CH and one for HW.
- Honeywell ST6400C controller that everything is wired to
- Honeywell wired thermostat to turn on CH
- Do I need wired or wireless (plus hot water controller) kit? Ideally I'd replace the entire Honeywell controller so go for wireless, but there are an insane numbers of wires currently that I know is not going to be straightforward as the tado guides show. Im confident if I go for the wired kit, I leave the Honeywell controller all the same, but replace the thermostat giving remote control ability. Won't get rid of old controller sadly and be able to set hot water schedules directly from my phone
- Is there any way to keep the immersion heater live using tado. Tado controller only supports 3amp. Somehow the current Honeywell controller I think controls the immersion heater too
- If I got for wireless and attempt to use the hot water control unit, should I get UK or EU version for best control of the boiler? Reading other posts, I'm confused if I need to use to use (EMS?, HT-BUS, relay On/off). I'm fairly sure it's not opentherm compatible
- Is there any reason to go for the X instead of V3. I don't care about matter support or app features. Just in terms of installation/boiler configuration
Cheers
Last edited:



