The monobloc I have just fitted came with it's own flexi pipes.
The flexi's that I have fitted on other taps around the house have had a 15mm compression nut/fitting on the other end so fit straight onto 15mm pipe.
These have a female 1/2" bsp tap connector on the end. The thread fits a 15mm compression coupling, but will it seal sufficiently? It has an integral rubber washer so I guess it will, but wonder if there is a specific fitting for this?
If this method is OK, can you get solder ring fittings with a male thread (1/2" bsp) on the end? Had a quick look in Screwfix and the only ones they sell are solder to 1/2" nut (female).
The flexi's that I have fitted on other taps around the house have had a 15mm compression nut/fitting on the other end so fit straight onto 15mm pipe.
These have a female 1/2" bsp tap connector on the end. The thread fits a 15mm compression coupling, but will it seal sufficiently? It has an integral rubber washer so I guess it will, but wonder if there is a specific fitting for this?
If this method is OK, can you get solder ring fittings with a male thread (1/2" bsp) on the end? Had a quick look in Screwfix and the only ones they sell are solder to 1/2" nut (female).