I’m building a porch and tiling it with double Romans’.
I want 5 full tiles but if I lay them on the floor one side starts with a flat and ends in a hump and the other side is the opposite.
If i’m going to use a dry verge kit does it matter if I finish on a flat or a hump?
And should my facia board finish 60mm from the last tile edge?
Thanks.
This is where i’m at, I put a big overhand on it just to hold the plastic sheet temporarily (and I think I ballsed up for a decent facia on the sides).
I want 5 full tiles but if I lay them on the floor one side starts with a flat and ends in a hump and the other side is the opposite.
If i’m going to use a dry verge kit does it matter if I finish on a flat or a hump?
And should my facia board finish 60mm from the last tile edge?
Thanks.
This is where i’m at, I put a big overhand on it just to hold the plastic sheet temporarily (and I think I ballsed up for a decent facia on the sides).