Separate circuit direct from supply to bypass main CU

Status
Not open for further replies.
If your main isolator is tripping then it isn't a main isolator.
Cheaper safer easier fix would be a UPS or other battery backup for the door mech.
Even cheaper fix is just go through the house & reset on those rare occasions
 
Sponsored Links
Perhaps his main switch is an RCD (RCCB).

Although that doesn't really tie in with the original post.
 
If your main isolator is tripping then it isn't a main isolator.
Cheaper safer easier fix would be a UPS or other battery backup for the door mech.
Even cheaper fix is just go through the house & reset on those rare occasions

Already have a battery backup and no internal door to garage. Thanks though.
 
I might be wrong on the main switch tripping guys, I’m getting confused now (been a long day!). Will test the RCD in morning and see what happens.

In the meantime I’ve just found this pics on my phone. Will get a cover off pic in morning for you.

Thanks for your help.
 

Attachments

  • D06E124F-60A0-4AAF-92AA-1A74D3A10954.jpeg
    D06E124F-60A0-4AAF-92AA-1A74D3A10954.jpeg
    167.3 KB · Views: 259
  • 50B2FACE-9BDE-4C83-BF54-BF007DFE262C.jpeg
    50B2FACE-9BDE-4C83-BF54-BF007DFE262C.jpeg
    190.5 KB · Views: 262
Sponsored Links
Can you do a picture of the consumer unit taken further back?

There may be a way of connecting in between the meter and the consumer unit.
 
Cool so I can take a feed from the load side of that then. Don’t even need a MCB downstream of it then? Just a cable to my garage door?

ABSOLUTELY NOT. The only upstream protection in that case would be your main fuse ~60-100A.
 
Father-in-law had same problem, cure was a key and lock which when unlocked withdrew the pin in the mechanism allowing manual operation, and a battery back up in the door so still worked with a power cut, just like a stair lift, where motor is 24 volt DC powered from batteries. I suppose you could fit an UPS, but that would limit how long the battery would last for.
 
Father-in-law had same problem, cure was a key and lock which when unlocked withdrew the pin in the mechanism allowing manual operation, and a battery back up in the door so still worked with a power cut, just like a stair lift, where motor is 24 volt DC powered from batteries. I suppose you could fit an UPS, but that would limit how long the battery would last for.

Thanks. Got both of them.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Status
Not open for further replies.
Sponsored Links
Back
Top