Are roll front and square edge worktops different depths?

[Draughtsman]

If a 600 deep (30thk) worktop or sit-on sink have a roll front, then this means that they actually measure up as 615 deep, because of the radius, right?

Thank you,

Dain

 

[big-all]

the size will be the full wdh as if the edges are flat

 

[foxhole]

Worktops can be anything from 10 - 50 mm deep, a width dimension at 600mm are just that whatever the edge finish.

 

[Draughtsman]

Worktops can be anything from 10 - 50 mm deep, a width dimension at 600mm are just that whatever the edge finish.

I just found a scrap piece of roll top worktop, 30thk and 615 deep?

 

[foxhole]

You mean 615mm wide? yes thats one of the many available sizes.

 

[Draughtsman]

You mean 615mm wide? yes thats one of the many available sizes.

but a 600 roll top sit on sink would be 600 INCLUDING front edge radius?

I suppose a 615 worktop would accommodate cutting the back edge to fit an odd shaped wall?

 

[foxhole]

Yes, comes in variety of sizes, better quality tops are 660-670 wide to allow for wonky walls.