Fuel floods out of mower when i pour it in

Joined
13 Nov 2008
Messages
1,504
Reaction score
29
Location
Avon
Country
United Kingdom
I used this mower for quite a while & never an issue.
Ive used it this season now for 3 weeks & fine.

Cutting the lawn today it started to chug & i knew it was running low on fuel.
After a short while it stopped.

I poured the fuel in the tank & watched it run out just as fast ??????

Ive taken carb off & blown through inlet pipe where fuel hose was.
Its fine & when i operate the float im then unable to blow unless i let float go.
I cleaned carb anyway & put it back together.

Poured a small amount of fuel in & out it came again.

I can see it coming out of carb where air filter mounts on.
Also the opposite end where carb mounts against that o ring engine side.

Why is it doing this ?

I know its warm & sunny here but surely thats not the answer or is it ?
 

Attachments

  • EaseUS_2026_04_ 7_14_09_16.jpg
    EaseUS_2026_04_ 7_14_09_16.jpg
    140.8 KB · Views: 14
  • EaseUS_2026_04_ 7_14_09_22.jpg
    EaseUS_2026_04_ 7_14_09_22.jpg
    83.2 KB · Views: 15
  • EaseUS_2026_04_ 7_14_09_29.jpg
    EaseUS_2026_04_ 7_14_09_29.jpg
    73.8 KB · Views: 14
  • EaseUS_2026_04_ 7_14_09_36.jpg
    EaseUS_2026_04_ 7_14_09_36.jpg
    99.8 KB · Views: 12
Last edited:
Ive put the carb in a glass & slowly filled it with water.
I can watch the float rise to the top no problem.

So i would say float is fine
 
Petrol is less dense than water. If the float is full of petrol it will float in water.
 
The float seems light meaning no fuel in it.

I just conncted fuel pipe back on & held carb in my hand & fuel came out again.

So answer me this, IT can only be the float at fault here correct ?
 
Looks fine.
I see fuel coming from between carb / engine block also opposite end towards air filter

I see no fuel in float.
I operate float & unable to blow.
I let got of float & i can blow fine.

I see no reason for it to do this,
 
So for the 5th time I’ve had it apart & back together again.
Done nothing different & used same parts ie haven’t swapped anything.

I’ve just put fuel in tank & no leaks.
I’ve also just cut my lawn.
Even left it running for a few minutes & mower deck is dry.

Very strange.
Now I need to add 3 extra gardens to my list of jobs tomorrow as had to end early today.

I will check fuel level in tank tomorrow to see if it’s still there or drained out over night.

But a right puzzle of a job
 
I hold it and unable to blow.

I’ve watched it for 20 minutes and not a drop has come out.
The needle rubber tip seats and that’s it.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top