- Joined
- 2 Feb 2007
- Messages
- 105
- Reaction score
- 0
- Country
Good morning.
Yesterday I was asked by a friend to help him wire a few connections in his shed. To cut a long story short he has 2 single sockets wired in a ring from an RCD in the shed. He wants to come off one of these to a FCU and then wire from this with a 3amp fuse to a light via a switch. The sockets run on 2.5T&E and the lighting 1.5T&E,
now would I be right in saying that the cable between the socket to be spurred from and the FCU should be 2.5T&E and then 1.5T&E from that point?
I my mind to be correct it should be 2.5T&E, but 1.5T&E can run 15amps, again is this right?
Thanks.
Yesterday I was asked by a friend to help him wire a few connections in his shed. To cut a long story short he has 2 single sockets wired in a ring from an RCD in the shed. He wants to come off one of these to a FCU and then wire from this with a 3amp fuse to a light via a switch. The sockets run on 2.5T&E and the lighting 1.5T&E,
now would I be right in saying that the cable between the socket to be spurred from and the FCU should be 2.5T&E and then 1.5T&E from that point?
I my mind to be correct it should be 2.5T&E, but 1.5T&E can run 15amps, again is this right?
Thanks.