garage

I'm going to seperate the garage to create a utility room and was wondering if a stud wall can be used instead of block work? If so, what depth should the timbers be and what PIR board to use? I've seen Wickes stud work timbers are 89mm but PIR board is either 75mm or 100mm.

Hello, I've recently moved in to a property and I am planning on replacing my garage with an extension. My garage is linked to my house but detached from my neighbours. My neighbours garage is completely detached. However, the two garages are very close to one another. They both have pitched...

My flat garage roof has been leaking and lack of funds means I'm having to tarp it. I have a load of old bricks so I was thinking of loose-laying a couple of courses down the centre then putting the tarp over thus forming a tent. The idea is that the tarp will last longer as any rainwater...

After being in our latest house for about 6 months, I'm thinking of building a log cabin at the end of our garden about 40-45m back from our garage, but I need to be sure that we can safely and effectively supply it with electricity before even starting the project. Connecting directly into the...

Hi I have reviewed some previous posts but I am not sure of the size of SWA cable to use for a garage and workshop. I am only planning to put the cable under the floor before some laminate gets laid - I am yet to get planning permission for the garage - but thought I would save an awkward job...

Hi, this is my first ever post so please be gentle. I have a garage in a block of two and I would like to make it a little better for storage. As it's all very open around the top (the dividing wall only goes up to the bottom of the roof slope) I was wondering if a ceiling might help as a first...

I have an attached garage, which is part of an extension that was built in 2003. It is unheated but usually stays at least 5c above the outdoor temperature. The ceiling is plaster-boarded and artexed, but there is a gap around the edges, between the plasterboard and wall. It varies in width...

Hello all, I have a flat felt roof Garage, which is in the middle of a large block. There’s a substantial amount of water ponding on top in a bottom corner. (I cleared this today along with cleaning out the guttering) There’s no guttering at the rear where the ponding is, only at the front so...

I want to get more light into my garage, if I get a new window installed overlooking my own property, do I need pp or Building Regs approval? Reading online there doesn't seem to be a clear answer. Any help very much appreciated

Hello All I have had a look on the planning portal website but not making much sense. I was just wondering if anyone had any advice before I pay the fee my local council charge for asking them if I need planning permission. I have a semi-detached house with vehicular side access. I currently...

Hi all, I'm fitting a small utility area at the back of my garage with some worktop and cupboards on the wall. Following building work the back wall has ended up a combination of brick, breeze blocks and some smaller areas of cement infill, so I'm looking at plastering it. Part of the wall backs...

Looking at renovating my garage in the near future, however I've no idea how serious the cracking in some of the concrete roof beams are. It's an old concrete sectional garage (no idea how old), and some of the beams have crumbled to the point which the rods are exposed and rusting. I've not...

I have a garage which is built with the walls sitting on the concrete slab, with a DPC at floor level, single skin brick. Parts of the walls are below ground, when it rains water seeps through the DPC. I've dug out and exposed one side and will cut back the DPC as close to the brick joint as...

Hello, Hopefully a straightforward question (and hopefully I'm posting this in the right place), I have little to no DIY skills, but I'm working on it! We have an old Garage/Outbuilding that has been in a state of disrepair since long before we bought the house. We finally have a bit of time...

I only have one plug point in my external modern double garage and need extra sockets added. The main power cable enters the garage into a stand-alone fuse box. The 2 gang socket is mounted beside it. I would like to run an additional 2.5mm cable from the back of the socket and run a 7 metre...

So I have started my workshop build today... Finally! I am knocking down my current garage to make way for a double story side extension on my house so need the workshop to house all my tools and junk. (See...

Hi all, I'm after some advice please. The lintel above my garage door is cracked (see pictures) and needs replacing (along with the garage door). The garage roof is pretty thick concrete... I've had 2 builders come round so far to look at the job, the first one says that as the lintel and the...

It is proposed to create a storage room utilizing the roof void above an integral garage. The span is 9' (2740) Plan to use 6x2 (47x150) rough sawn treated timber joists hung from wall plates at 450mm centres with 1 (offset) row of noggins. (I've checked these against tables and this size timber...

Hi! I'm building a large shed/workshop (6x3.5m) at the top end of our garden. It might potentially have a car in it on occasion. I have read that 100mm should be deep enough. I have dug down to subsoil with a digger as it was on a slope. My question is 2 fold. Firstly, should I be using...

Hi, I have a 1970s house which has an attached garage with the original roll down garage door. I added some polystyrene insulation on the inside of the door, and brush draught excluders on the sides. Its still quite draughty though. The front half of the garage is single skin brickwork, Im...