Hi all.
I have a new single built under oven for my kitchen install the other day which is great. Rated at 2800 in the book so has a plug already fitted which sounds fantastic and nice and straightforward!
Trouble is, i have a 6mm feed (from the old electric hob - new one is gas) where they are going to be installed.
I could just extend into the ring or spur off the sockets above the worktop to include 13a FCU's for the two but i was trying to think of utilising whats already there - the 6mm supply (which i want to keep incase i use a larger load oven / hob in the future)
Is it advisable/possible to hardwire the oven directly to this or use the 6mm fused down to a 13a FCU for the oven?
Any suggestions welcome.
I have a new single built under oven for my kitchen install the other day which is great. Rated at 2800 in the book so has a plug already fitted which sounds fantastic and nice and straightforward!
Trouble is, i have a 6mm feed (from the old electric hob - new one is gas) where they are going to be installed.
I could just extend into the ring or spur off the sockets above the worktop to include 13a FCU's for the two but i was trying to think of utilising whats already there - the 6mm supply (which i want to keep incase i use a larger load oven / hob in the future)
Is it advisable/possible to hardwire the oven directly to this or use the 6mm fused down to a 13a FCU for the oven?
Any suggestions welcome.