Search results

  1. M

    Dripping mixer tap - how do i get to the washer please

    Hi, This tap is dripping quite badly now, how do i access the washer to replace it ? tia, Mike
  2. M

    Help sourcing a heating element for Lamona oven ?

    Hi, I've been told by a supplier that we purchased a Lamona LAM3201 fan oven from them which we need a replacement heating element for however i'm really struggling to locate one. Nothing on ebay seems suitable (only grill element) and i'm not sure where else to turn. It's getting quite...
  3. M

    Testing power to pump with a multimeter

    Hi, I've got a sewage pump that is broken. Before i start the expensive job of replacing i just want to check their is power to it using a multimeter. I've checked the fused spur and trips and all appear well but wanted to make sure there is a current passing through the cable into the pump...
  4. M

    Lagging / casing external pipe

    Hi, I've recently had to have an high strength external grey pvc pipe routed from my pumping station in a basement flat to a nearby drain which is 2m higher than the pump. The pipe will always have a head of water in it so i need to lag and case it before ther really cold weather arirves...
  5. M

    Vokera Boiler wont power on - what electrical checks ?

    Hi, I have a vokera compact 28 that wont power on, i've replaced the fuse on the spur but suspect the PCB may be gone. I've taken it out and reconnected everything but no power still. Do i just need to check there is current arriving at the board ? The fuse on the PCB seems to be ok still as...
  6. M

    Blocked inlet to sewage pumping station - best way to clear ?

    Hi, I've a small pumping station for a basement flat. The chamber has previously stopped working when the float was covered in crud (FOG) but i cleaned it and all was well. The station has again stopped working but this time the float is clear but no water is getting into the chamber. I've...
  7. M

    Please help - Vokera boiler barely working.

    Hi, I have a vokera compact combi that's barely working at the moment. When the heating is on the boiler fires up and stays on for about 60secs but then strangely thinks the rads are up to temp and goes into its dormant mode, a short while later it comes back on and shuts off again after...
  8. M

    Central heating advice and possible boiler replacement

    Hi, We live in a 4 bed detached which has had a Vokera Compact 28 boiler for about 12years now. Of late we are seeing the occasional problem with it and wondering if it's on its way out ? - what is the life expectancy of a boiler ? The system seems to be struggling to heat the rads properly...
  9. M

    Electrical sign off for new wiring, level of qualification ?

    I've had a problem with a contractor whereby he's left a rewire for a new flat part way through leaving his colleague to finish off. The colleague is only part qualified but keeping the business as a going concern. To sign off the work what level does he need to be qualified to ? tia...
  10. M

    Electric Panel Heaters - clearance height needed ?

    Hi, I'm having some panel heaters installed in a basement flat but my electrician has said the fittings instructions say the panel needs 2m clearance above it !....this seems very excessive to me and wont be possible as the ceiling height is only 2.1M and i dont want them sitting on the...
  11. M

    New water supply when splitting property into 2 flats ?

    I own a property that i'm in the process of converting into 2 flats. There is a water supply into the building that i'd hoped to split into 2 to feed each flat. Yorkshire water told me i had to install a separate new feed and have quoted me a staggering £2500 to lay a small length of pipe to...
  12. M

    Splitting water feed in building for flats - can i ?

    Hi, I'm splitting a 2 storey building into 2 flats. Can i take the existing water feed and branch it into 2 thus feeding both floors ? I'll be letting the flats so hope to pay the water bill myself but charge the tennants monthly. Am i ok to do this ? tia, Mike.
  13. M

    Can tenants move in without sound test signed off ?

    Hi, I'm converting 2 flats, one is a few weeks off completion the other a couple of months. I've just asked the sound consultant when they are able to test the 1st flat and they say it can only take place when both are complete - is this correct ? Could i move a tenant in the 1st flat...
  14. M

    Can airbricks in chimney breasts cause sound tests to fail ?

    My builder tells me we must have air bricks in the chimney breast to avoid condensation and damp as the flats i'm developing are so well insulated. However my concern is that sound could travel down the chimney breast and through the air brick causing the sound test to fail. What's the best...
  15. M

    How far from the tap can small water heaters be housed ?

    Hi, I'm looking to use something like this to heat the sink water in a small bathroom http://www.alertelectrical.com/prodvar/5316/wijas-perfect-p3500b-35kw-undersink-water-heater?&utm_source=google-base&utm_medium=web&utm_campaign=google-base-feed&gclid=CKW9rMzK-bsCFW_MtAod5HUArg The...
  16. M

    What size zip boiler for a small bath ?

    Hi, I'm trying to decide whether to install a small bath (1500mm) in a flat i'm developing. The flat only has electric heating so will need a zip boiler for the bathroom sink and bath ( if i fit one) - what size is needed to fill a small bath in a reasonable time ? tia, Mike.
  17. M

    Wall lining system - wood or steel, which is the cheaper ?

    Hi, I need to wall line most of the external wall on a flat i'm developing. My builder suggest 2x2 stud but i know 50mm steel frame is another option. Cost wise is there much in it ? TIA, Mike.
  18. M

    Kitchen sink in unit with no back - how to stop water splash

    Hi, I'm renovating a flat and planning the kitchen - at present the best place for the sink is in the worktop that protrudes into the room with no partition behind it. What is the best way to stop water splashing back onto the carpet behind the sink area ? Cheers, Mike.
  19. M

    Please advise on floor soundproofing mistake in a flat

    Hi, I'm renovating 2 flats and have been soundproofing the floor between the 2. Sadly a combination of ambiguity on the soundproffing spec and an oversight by my builder have left me with a problem to resolve. Basically the following sketch shows deck 18 as the top part of the floor which...
  20. M

    what is the standard height of a sink waste pipe ?

    Hi, I'm hoping to fall a sink waste pipe to a gulley outside the property. The pipe run length is about 6m, will i have enough fall to do this ? Is the rule of thumb about 3" fall per metre ? So i'll need it be 18" minimum off ground level ? tia, Mike.
Back
Top